The main malfunctions of the generator

There is no voltage and the generator works without a load, (for one of the following reasons)

- AVR circuit fuse is damaged

- The presence of shorts in the circle of unification mounted on the X

- Separation or shorts with auxiliary fixed body coils

- Separation of the auxiliary coils feeding the AVR circuit

- Loss of residual magnetism (for modern generators that do not need external DC power)

- Generator speed is low

- Separation in the secondary coil of the control transformer

The generator voltage is low and it works without load (for one of the following reasons)

- Damage to the unification circuit installed on the Ax

- Generator speed is low

The air gap of the control adapter is very small

- Decreased file isolation

The generator voltage is high and it works without load, (for one of the following reasons)

- The presence of shorts in the secondary coil of the control transformer

- Generator speed is high

The air gap of the control transformer is large

The generator voltage drops when loading, (this is for one of the following reasons)

The load is greater than the generator capacity

- Double diesel engine

Decreased isolation of auxiliary or main body coils

The generator voltage is not fixed (wobbly), (due to one of the following reasons)

The generator speed is not fixed

- The terminals of the control circuit are not good (Bad contact)

- Overload

- Cooling air passages are not clean, covered with dust

Decreased file isolation.

3tk